Installation methods and measurements may vary from model to model – check the installation manual or consult your contractor for more details.
Step 1: Take the hoses out of the holders.
Step 2: Unscrew and remove all four transport brace screws using a WA17 wrench.
Step 3: Remove the sleeves. To do this, remove the mains cable from the holders.
Step 4: Fit the covers. Lock the covers firmly in place by applying pressure to the snap-in hooks.
Level the appliance using a spirit level. Incorrect leveling may result in intense noise, vibrations and "wandering"
1. Loosen the lock nuts using a WA17 wrench, by turning it in a clockwise direction.
2. Check the alignment of the washing machine with a spirit level and adjust the height of the appliance feet if necessary. All four appliance feet must stand firmly on the ground.
3. After adjustment, hold the foot firmly and tighten the lock nuts with the WA17 wrench by turning in an anti-clockwise direction.
The washing machine can be connected to the water inlet and outlet either on its left or right side.
1. Connect the water supply hose to the water tap (3/4” = 26.4 mm) and to the appliance.
2. Open the water tap carefully, checking for the leakages and tighten if necessary.
If the attached drainage hose slips out of the washbasin due to high water pressure when draining the washing machine, leaking water may cause damage. Secure the drainage hose to prevent it from slipping out of the sink.
If the end of the drainage hose is immersed in the drained water, water may be drawn back into the appliance!
If the drainage hose slips off the siphon connection due to high water pressure when draining the washing machine, leaking water may cause damage. Connection point must be secured with hose clip, Ø 24–40 mm.
If the drainage hose slips off the plastic pipe due to high water pressure when draining the washing machine, leaking water may cause damage. Secure the drainage hose to prevent it from slipping out.